I am running Office 2003 SP3.
I am used to viewing all procedures in a given module in one window with separator bars between each procedure.
My display has switched to one procedure at any one time visible in the window. I cannot recall the keystrokes required to set/reset the switch which controls this.
Help.
Display of VBA Code
-
- 5StarLounger
- Posts: 689
- Joined: 27 Jan 2010, 16:45
- Location: Ottawa, Ontario, Canada
Display of VBA Code
Regards
Don
Don
-
- Administrator
- Posts: 78594
- Joined: 16 Jan 2010, 00:14
- Status: Microsoft MVP
- Location: Wageningen, The Netherlands
Re: Display of VBA Code
In the Visual Basic Editor, select Tools | Options...
In the Window Settings section of the Editor tab, tick the check box "Default to Full Module View".
Click OK.
In the Window Settings section of the Editor tab, tick the check box "Default to Full Module View".
Click OK.
Best wishes,
Hans
Hans
-
- 5StarLounger
- Posts: 689
- Joined: 27 Jan 2010, 16:45
- Location: Ottawa, Ontario, Canada
Re: Display of VBA Code
Thank you Hans.
The box was already checked; however unchecking it followed by OK, then resetting it did the trick.
The box was already checked; however unchecking it followed by OK, then resetting it did the trick.
Regards
Don
Don
-
- Administrator
- Posts: 78594
- Joined: 16 Jan 2010, 00:14
- Status: Microsoft MVP
- Location: Wageningen, The Netherlands
Re: Display of VBA Code
Apparently a bit fell over, perhaps it was hit by a cosmic ray...
Best wishes,
Hans
Hans
-
- 5StarLounger
- Posts: 689
- Joined: 27 Jan 2010, 16:45
- Location: Ottawa, Ontario, Canada
-
- 4StarLounger
- Posts: 475
- Joined: 21 Feb 2020, 21:27
- Location: Vermont (USA)
Re: Display of VBA Code
—Nick
I’m only an egg (but hard-boiled)
I’m only an egg (but hard-boiled)