Hi,
Is it possible to modify the TOC as follows:
The TOC shows heading levels 1 and 2
For heading 1 levels it must have the Header entry and a tab leader and page number
For heading 2 levels it must only have the Header entry (no tab leader or page number)
If so..how do I do this. TX.
TOC design
-
- gamma jay
- Posts: 25455
- Joined: 17 Mar 2010, 17:33
- Location: Cape Town
TOC design
Regards,
Rudi
If your absence does not affect them, your presence didn't matter.
Rudi
If your absence does not affect them, your presence didn't matter.
-
- gamma jay
- Posts: 25455
- Joined: 17 Mar 2010, 17:33
- Location: Cape Town
Re: TOC design
Sorry...as per usual the lounge magic works again. Post a question and have it inspire one to find an answer...
Here is the answer for the benefit of anyone else.
Use the switch: { TOC \n "2-3" \h \z \u }
Answer found here, under the heading: Omitting page numbers
Regards,
Rudi
If your absence does not affect them, your presence didn't matter.
Rudi
If your absence does not affect them, your presence didn't matter.
-
- Administrator
- Posts: 78238
- Joined: 16 Jan 2010, 00:14
- Status: Microsoft MVP
- Location: Wageningen, The Netherlands
Re: TOC design
See Field codes: TOC (Table of Contents) field for an overview of the available switches for the TOC field.
Best wishes,
Hans
Hans
-
- gamma jay
- Posts: 25455
- Joined: 17 Mar 2010, 17:33
- Location: Cape Town
Re: TOC design
Nice summary, TX.
There are some nice options to enable some tweaking on the TOC.
I like tweaking...only problem is sometimes it breaks!
There are some nice options to enable some tweaking on the TOC.
I like tweaking...only problem is sometimes it breaks!
Regards,
Rudi
If your absence does not affect them, your presence didn't matter.
Rudi
If your absence does not affect them, your presence didn't matter.